吸塑正面划痕（装机部分不许有划痕），长度在5.0MM，宽度在0.2MM

吸塑正面划痕（装机部分不许有划痕），长度在5.0MM，宽度在0.2MM以内，目视不明显，触及无手感，同一面不得超过两处，及相邻两处相距在10.00CM以外，可接收（AC），反之则拒收（RE）

Results (English) 1:

Plastic face scratch (installed part not scratched), length 5.0MM, width is less than 0.2MM, no obvious Visual, touch no touch, with not more than two, and the distance between two adjacent outside 10.00CM, receiving the (AC), otherwise reject (RE)

Results (English) 2:

Blister front scratches (chassis part must not have scratches) in length 5.0MM, width less than 0.2MM, visually obvious, touch no touch, with one side not exceeding two, and the adjacent two apart in 10.00CM outside, can be received (AC), otherwise rejected (RE)

Results (English) 3:

Plastic front scratches (part of the machine is not allowed to have scratches), length in the 5.0MM, the width of the 0.2MM, the visual is not obvious, touch no feel, the same side shall not exceed two, and the adjacent two are apart from 10.00CM, can receive (AC), and vice versa (RE)